DAT QE2525SMADAT QE3030S

DAT QE2626S

PDFPrint
DAT_QE2626S.jpg

Single wide stretcher decon shower system to handle 1 non-ambulatory victim w. attendants, 4 multiple function trigger guns, approx. 7'W X 13'L X 8'H, 90 sq. ft., 145 lbs.

Description

Single wide stretcher decon shower system to handle 1 non-ambulatory victim w. attendants, 4 multiple function trigger guns, approx. 7'W X 13'L X 8'H, 90 sq. ft., 145 lbs.

 

Files:
Name File size    
2011_dat_qe_shelters 1001.09 KB

decon_manual_2016 5.92 MB

Technical Specs

 

‘Quick Erect’ General Set up and Tear down Instructions:

 

All parts are pre-assembled with no special tools required. All components are of telescoping aluminum with locking hinges, caps, and scissor connected support frames and guide rails for ease of movement for ‘Quick Erect’

 

To ‘Quick Erect’ simply release handle lock, have 2-4 support personnel grip side frame & pull the width support frames slowly – until all hinges lock. Ease roof frame upwards. Then pull the Length support frames until locked. Check and final position canopy, floor and decon pool. Commence use.

 

Standard color is ‘EMS’ blue exterior w. high visibility white inside color. Green and White exterior also available at no extra cost. Other colors optional with an extra charge.

 

The FSI DAT® QE2626S is a one -line wide 7' W X 13’ L X 8’ H (2.13 M X 3.95 M X 2.43 M), Single Non-Ambulatory Decon Shower System meant to handle a single stretcher borne victim with attendants working on either side. Can also be used to decon 2 walking wounded personnel at a time. This unit deploys in approx. 3 minutes, and processes one stretcher borne or 2 walking victims at a time.

 

The shower station includes 4 hanging coiled ½”/13 mm hose lines with attached multiple function spray nozzles which thoroughly drench and decontaminates via a fine water mist. Shutoffs and quick disconnects supplied with every trigger gun. Flows per spray gun = approx. 1 gpm/ 4 lpm optimum and dependent on water volumes available. As an option -- one can double the capacity if required.

  

Wastewater is contained within integral ground floor and 8”/20 cm pop up berm erected when system is initially set up (holds approx. 220 gallons – 880 litres - of waste water before pump-out is required).

 

Includes full closure slip in and out dirty entry/clean exit doors on each end, two roll up windows (one on each side), 2 skylights, 6 stainless steel stakes and ground anchor points, tie down ropes and 4 D-rings to tie off to, repair kit, manual, carry bag, 2 upper air vents, 2 HVAC/dirty clothes ducts with tie closures, and hammer. All canopy walls are velcro’d to the floor berms for air lock, and reflective striping is found on the upper air vents above doors and on entry and exit integral shower stall air berms.   Units can attach to a second shower or FSI shelter.

 

Simply set up the unit and plug into a water supply. DAT® QE2626S offered with integral ground floor, 1 – ¾” (18mm) High pressure 300 psi (20 bar) GHT threaded inlet hose – other fittings available as specified. Decontamination can commence in approx. 3 minutes.

 

Multiple optional accessories available inclusive of air and water heaters, air coolers, elevation grids, waste water pumps, etc. available.

 

Unit supplied w. no charge redundant features allowing for - hanging undress/redress kits etc. on the inlet and outlet side and - doubling of showering capability in the future.

 

DAT® QE2626S Approx. 91 sq. Ft. (8.5M²), 145 lbs. (66 Kg)

 

Carton size approx. = 149 X 66 X 45 cm (59” L X 26” W X 18” H)